It’s little secret that stepper motors are everywhere in FDM 3D printers, but there’s no real reason why you cannot take another type of DC motor like a brushless DC (BLDC) motor and use that instead.

This is another of my attempts to control a dc motor, the first one was successful but this time I'm modifying some components for a higher voltage workload. List of equipment I use Cameras Sony a6300 ...

BC7595 -- 6 digits 7-segment LED display with 48-key key matrix driver BC7591 -- 32 digits 7-segment LED display with 96-key key matrix driver This library is available for all Arduino devices, and ...

Abstract: This article proposes an adaptive fault-tolerant cooperative optimization control strategy for permanent magnet synchronous motor (PMSM) servo system with actuator faults, input saturation, ...

This library allows you to make the ESP32 act as a NimBLE-Arduino 2.x Keyboard and control what it does. The BleKeyboard interface is almost identical to the Keyboard ...

Abstract: The permanent magnet synchronous motor (PMSM) servo systems can only drive loads with relatively low inertia due to the limitation of the ratio between load inertia and rotor inertia ...