Building a DIY environmental sensor for under R550

The BME280 sensor was easier to set up, as it communicates over the I2C serial protocol. This means that we only needed to ...
Hackaday

Drive 1024×600 Pixels Via I2C With An ATtiny85

If you need to drive a big screen for a project, it’s fair to say your first thought isn’t going to be to use the ATtiny85.
Hackaday

A UI-Focused Display Library For The ESP32

If you’re building a project on your ESP32, you might want to give it a fancy graphical interface. If so, you might find a ...
CNX Software

Xibo open-source digital signage solution now works with Raspberry Pi 5 thanks to the Arexibo project

Xibo digital signage solution is now compatible with the Raspberry Pi 5 thanks to Axeribo, an unofficial alternative to the ...
GitHub

The EnviroDIY ModularSensors Library

If you're new to EnviroDIY, I suggest you check out the Just Getting Started section of the documentation! This Arduino library gives environmental sensors a common interface of functions for use with ...
GitHub

Systemverilog implementation of an I2C slave with a simple register map. Multi-byte reads and writes supported with address auto-increment.

I have tasks to emulate the I2C master which allows the testbench to be very high-level (see simulation directory). This slave implementation has been tested with FT4222 and Raspberry Pi I2C masters.